Cable drop compensator corrects remote load regulation errors without sense wires

April 18, 2013 // By Paul Buckley
Linear Technology Corporation has introduced the LT6110 cable drop compensator, a new device that improves voltage regulation at remote loads without the need for Kelvin sense wires.

The LT6110, a new component for the designer, has been architected for use with most types of voltage regulators and can provide several volts of load regulation compensation.

The LT6110 will compensate for the voltage drop due to resistance in a wire, circuit board trace or cable and can improve regulation at the load by a factor of 10. It operates with supply voltages that range from 2 V to 50 V, making it suitable for high power USB, Power over Ethernet (PoE), remote instrumentation and remote industrial applications. The LT6110 reduces costs by eliminating sense wires which may be prone to misconnection or damage and it makes load regulation independent of wire size or length.

The LT6110 operates by measuring the load current with a sense resistor and injecting current into the existing regulator’s feedback loop to raise the output voltage. The device is designed to work with standard feedback circuits, as well as new 'current source' reference devices such as the LT3080. For load currents less than 3 A, the internal 20 mOhm sense resistor simplifies the design. Wide bandwidth achieves fast transient compensation of load steps, and in most cases the savings in wire and labor are more than the cost of the LT6110.

Availability and Pricing

The LT6110 is fully specified for operation from –40°C to 125°C and is offered in SOT23 and 2 mm x 2 mm DFN packages. The device is now available, priced starting at $1.29 each in 1,000-piece quantities.

More information about the LT6110 cable drop compensator at