•  
• EDN Europe MAGAZINE
•  
• Free SUBSCRIPTION
• Subscription Renewal
• View Media Kit

• EDN
• EDN Australia
• EDN Asia
• EDN China
• EDN Japan

Voltage-to-pulse-width converter spares microprocessor’s resources

Although not an ADC in the classic “stream-of-ones-and zeros” sense, this voltage-to-pulsewidth converter produces a logic-level output pulse whose variable width represents an analog of the input voltage. Based on Atmel’s (www.atmel.com) AT89LP4052 microprocessor, IC₁, this circuit makes efficient use of the target microprocessor’s limited analog-port pinout and code space by using a modified version of the classic timed-discharge-RC (resistor-capacitor) ADC design. The timed-RC ADC allows a capacitor to charge through a resistor while the microprocessor increments a counter. When a comparator detects that the capacitor voltage and analog-input voltage are equal, the count terminates, and its stored value represents the ADC’s output. However, an RC network’s exponential charging characteristic produces a nonlinear conversion. Various software and hardware techniques can partially correct the nonlinearities, but all entail adding code, increasing the circuit’s development time, or consuming additional I/O-port pins required for other purposes. To produce a linear-charging characteristic that needs no correction, the circuit in Figure 1 uses an LM334 constant-current source, IC₂, to drive capacitor C₂, which connects to IC₁’s AIN0 analog-input port. An internal timer in the microcontroller measures the elapsed time from the charging ramp’s start to the instant when the ramp voltage crosses the analog-input-voltage threshold at IC₁’s AIN₁ port. In this application, potentiometer RV₁ provides an analog-input voltage proportional to its position. The width of the positive-going pulse at the output, P1.5, varies in proportion to the analog-voltage input. Note that I/O-port pin AIN₁ serves a dual purpose as an analog input and as an open-drain output that discharges ramp-forming capacitor C₂ before the next conversion cycle. An 8-bit voltage-to-pulse-widthconversion cycle completes in less than 4 msec. The code performs the conversion function and outputs a pulse train at IC₁’s port P1.5 (Pin 17) with a period of 100 msec and a positive-going pulse width proportional to the analog-input voltage at Pin 13 (AIN₁). Programming connector J₁ provides access to IC₁ for uploading the compiled code. The AT89LP4052 microprocessor typically executes one instruction per clock cycle, and a 10-sec timer routine can perform the required housekeeping functions with plenty of time left over for other program tasks, including a future application that requires a binary-coded analogto- digital output. You can download Listing 1, which is written in C for the Keil Software (www.keil.com) compiler, from the online version of this Design Idea at www.edn.com/061201di1.